Marvell Raid Driver Windows 10

Aug 08, 2015 I just updated my computer to Windows 10, and am having the same issue. Gigabyte GA-X58A-UD3R motherboard with Marvell RAID. Canon Lide Windows 10 Driver. Intel Me Driver Windows 10 Msi more. Was working fine on Win7 Pro, now on.

It sounds like your board's Marvell SE9230 chip that supports the HypoDuo Service does not have its driver installed, and possibly needs the Marvell MSU Utility installed too. No Windows 10 drivers listed yet for that chipset on your board's download page, and Win 10 does not have a Marvell driver built into it. You can try the Window 8.1 version of this driver from your board's download page: The Marvell driver was installed at some point for your Windows 7 installation, but seems to have been removed or replaced with the wrong driver during the Win 10 installation. Check Windows Programs and Features to see if the Marvell SATA driver and MTU software are still there. Otherwise, the three things you listed as updated have nothing to do with the Marvell SATA chipset. Re-Installed Under Marvell BIOS etc. Drives SSD and Mechanical Main Drive show and Initialize as expected.

Use Windows 8.i 64 bit MSU It says SSD not found, clicking on Adaptior 0>Operation>Create HyperDuo = No SSD reported: but this SSD drive shows below, SSD drive is connected and works etc. Create RAID says: There are no available disks for creating. I cleaned off HyperDuo. All Drives seen as normal drives in Windows 10 if Marvell BIOS not set up, also shows on the left of the MSU: Testing the SSD, (in windows 10), formatted it to copy a file over to make sure it was working, then did Ctrl+M, on bootup for Marvel BIOS are re-settup SSD/HDD drives 'Initialising', Function', etc all seemed to work OK as expected in Marvel BIOS. Went back to MSU Windows 7 which just looks better, displays more, than Win 8.1 MSU to me. Still the same In MSU ss if no SSD and HDD drive is seen under MSU on the left but not on the right: Below is the SSD drive./.